Adjusting cutting blade Suffolk Puch 45s?

Well it worked for me - Pole £5 - cut 3 x 2" pieces - drilled centre 11mm cut 4 spacers from plastic pipe - one at each end and one each side of centre wheel.

Cutting height now increased by about 20mm.

Peccavi
March 2011

You might consider buying a wooden fencing pole - 4" diameter. Chop it up into a couple of pieces - drill the centres and slip perhaps three of them onto the front roller bar - using the original rollers as spacers.

This may give you the height you need.

In fact I might even try it myself...

Good luck...

Peccavi
March 2011