Fisher and Paykel GWL11 gets stuck in rinse cycle?
It drains the water in the rinse cycle but when all the water is gone it continues to try to drain until it stops and gives the error code 37. I have pulled the pump and checked it and I have investegated the pressure line to make sure there was no obstructions.
Put some water in bowl then advance to final spin & press start. Check flow rate of water from end of drain hose. If weak flow then either pump is running too slow or there is a blockage. If flow is fast then pump & hose is okay. Then check air pressure tube inside panel on right hand side. Take it off the controller & blow down it to remove any blockage. If fault still exists after that then it is probably a faulty control board.
Lincoln Appliance NZ
February 2013
I can answer this question...
Fisher and Paykel GWL11 gets stuck in rinse cycle?
howtomendit.com for free repair help, information and advice.
Try fixfault.com to fix washing machines.