why no led lights flashing on my magnetic sensors using with g3 alarm syste?

By the way, have you been doing ANY work around the cables going to any of the alarm detection?

Terry
December 2016

HOW, did you test the fuses?

Not knowing what control panel you have it would be impossible to comment on the use of the 'reset' switch you have in the panel.

Terry
December 2016

thanks for that,,,,,,no offence but have already tested all fuses, and battery correct way round,,,,,there is a small thing saying reset inside the main control box,,,,do I need to push or twiddle that. by the way, the mains fuse I had removed b4 opening the control box, thanks for your concern, but without a circuit diagram, I was hoping to cut out all the testing required with meters etc to draw my own circuit diagram,,,by asking if someone knew.Thanks.

rob faversham
November 2016

Oh and did I mention there was a mains supply in panel You were lucky you touched that!.

Electricity doesn't deal with ignorance lightly.
November 2016

You have blown a fuse in panel,you have either connected the battery backup wrong which I can't imagine why because it is virtually idiot proof, or you have messed around something else in panel.

You need to replace the fuse but tbh I would get someone competent to do so because you do not appear to know what you doing.

No offence
November 2016