Mend > Home Alarm Systems

5

how to reset my 9651?

front came down on panel causing ko1 tamper wont reset unable to use alarm

4

gardtec 800 alarm system reset?

I have a gardtec 800 series alarm system. This was installed by the previouse house owner. Last night the inte... [Read more]

2

I need a new battery ?

I need a new battery for my CK alarm system the number on the battery is NP6-12 6AH P6 valve regulated where c... [Read more]

8

What is an scb, I am wiring in a scant tonic alarm?

What is a scb

4

How can I enter?

I have a B&Q safe model no-SFT-20ED.The batteries have run out & I have lost the key can anyone tell me how I ... [Read more]

8

battery problem ford 302?

what would be the cause of a 1983 ford 302 V-8 battery drainage problem please

1

what would be the cause of battery drianage in 302 ford ?

the battery is draining at a rapain rate need to know the cause.

8

i have a melcom st6000 that keeps going off?

every time i use the hall light switch my alarm keeps going off and the red tamper light comes on...can someon... [Read more]

8

citadel xr2 alarm fault. please help!!?

Hi, I have a CITADEL XR2 alrm (Product Code: INT-XR2). We recently had a power cut and even though the lights ... [Read more]

4

scantronic 9800 entry/exit programming?

hi. i have a scantronic 9800 ,its been re programmed and have the following problem. entry and exit times are... [Read more]

5

How can I fix my OPTIMA XM intruder alarm?

I have a OPTIMAXM intruder alarm which we had installed in 1991 & has been working ok since then. Recently a f... [Read more]

7

tamper loop Scantronic 9427 alarm?

Tamper loop on my alarm panel is showing red any ideas on how to turn it back to green.

2

Hue change?

how can you change the colour of my strobe? at the moment the strobe is red, but my last alarm bell box str... [Read more]

5

I have scantronic 9000 series, ?

the red light is flashing and say call engineer. When the power goes off the alarm works ok. not sure if the b... [Read more]

2

mains flashing code?

hi there can any body help me with a problem i have with a micron scorpion z6L arlarm after replacing the back... [Read more]

3

Why is the alarm going off? Scantronic 9427 alarm?

I have a scantronic 9427 alarm. Every time I set the alarm, zone 6 flashes and the alarm goes off. I can clear... [Read more]

6

why does my strobe outside not flicker when not on?

why does my strobe outside not flash when not on

3

mains flashing code?

after replacing the battery back up in my micron alarm as per instucted by technician it continues to flash af... [Read more]

3

how do i stop it?

my omnicorn 9000s house alarm comes on ,on entry,this sarted aftera power cut.

4

9200 series Alarm?

The alarm as worked no problems for over the five years we have been in house, and had it serviced on moving i... [Read more]