Mend > Home Alarm Systems

Strobe won't go off?

I have an optima compact G3 alarm system. A builder has relocated the panic box thereby setting off the tamper... [Read more]

1

Scantronic 9000 series fault?

My house alarm has gone off and n0. 8 has appeared on the panel. This does not relate to any zones. Installed ... [Read more]

Scabtronic Avanti LCD XP ?

Easy guys, i know this not be much of a real issue but when the my alarm stops the strobe stops with it which ... [Read more]

Why would the internal alarm and arming beeps stop working?

Scantronic 9884 ( about 20 years old) The internal alarm and setting sounds has just stopped working. Everyth... [Read more]

veritas alarm reset phone number?

My home alarm is set to call 2 phone numbers when goes off the problem is them people no longer have these num... [Read more]

3

Fix a Logic 4 alarm?

We have just moved into this bungalow and do not have any instructions on use. It has a key, does it have a p... [Read more]

1

ADT Series 3200 plus?

I have a flashing c6 after the panic button was pressed by my toddler. Can see that it means circuit broken b... [Read more]

Accented alarm system no power on control settings alarm light flashing?

Power surge cause problems with alarm can't reset control panel no power Alarm light keeps flashing

Scantronic 9427 alarm starts on entering code?

When I am setting alarm to go out it starts up and lights up on 6 on left side .Have to put code to silence al... [Read more]

2

Can security code be retrieved have forgotten it?

Have forgotten code do you keep them on file?

2

no power too my 9427 alarm?

hi could you advice me please, there seems to be no power to my alarm, as its not lighting up or responding at... [Read more]

4

advanatge zx6 alarm zone 8 ?

i have the above system and it has started to sound the alarm when it is not set. zone 8 lights up red.any ide... [Read more]

8

How can I clear a supervision fault on scantronic i-on16?

2 sensors are reporting a supervision fault and low battery even after replacing the battery, do I need the in... [Read more]

1

how to remove error code t on guardtec 500?

My alarm has had a factory reset but when I now arm it comes up with the error t code and does not arm

1

red spanner on 9930?

Hi I have a red spanner permanently showing on my 9930. I am unable to set my alarm. The alarm will give of a ... [Read more]

Accenta ?

we set the alarm to go out but on our return the outside box is flashing and zone 2 red. could the battery be... [Read more]

1

scantronic 9200 home alarm?

I have a faulty 9210 scantronic alarm which had a faulty remote 9220 keypad-I bought a new keypad, same model ... [Read more]

1

Fault showing ef?

Hi, I put the downstairs alarm on last night, then I had to go downstairs again more or less straight away. Wh... [Read more]

How hard is it to find a decent alarm bellbox?

Hi all, I have tried to find a good bellbox for my alarm, I have tried all the texecom odyssey ranges but the ... [Read more]

Accenta remote keypad stays lit?

Hi I changed my daughters alarm system to Accenta mini gen4 is it normal for the accenta 8EP416 keypad that ... [Read more]