Mend > Camping Equipment

1

RM212f fidge?

It is not possible for the individual who asked this question to say thank you to you, so on their behalf than... [Read more]

carver cascade 2?

I have an Elddis Vogue 1V which has the Carver Cascade 2 hot water/heater system. When I switch on I get the g... [Read more]

1

pump keeps kicking in?

my trauma water pump keeps kicking in every 10 mins or so I have fitted a 1 way valve and there are no leaks ... [Read more]

how do you change seals on carver cascade 2 water heater?

how do you change seals on a carver cascade 2 water heater

1

3 way fridge?

my three way fridge works ok on 12 volt and 240 volt but when I connect to gas I cannot get it to work. ... [Read more]

1

vanette 7000 gas cooker?

vanette 7000 gas cooker will not rise to full heat just stays on low flame no matter what remp the dial is set... [Read more]

1

fuse board?

can anyone tell me where the main fuse board is in my abbey feestyle 400se i have found the one located under ... [Read more]

2

Carver 2 water heater fast drain valve?

Fast drain valve plastic has broken off in the thread. Anyone know easiest way to remove it. Also anyone know ... [Read more]

Repair of the roof raiser on my cardinal clubman?

The cable has come off the near side pully that raises the roof section when it is wound up. Can anyone help ... [Read more]

1

cascade 2 plus?

works fine on gas but mains elect. mode goes up to temp then always trips on over temp, press reset button a... [Read more]

1

I need a new cooker door for a GG7000 vanette?

I need a glass cooker door for a GG7000 vanette the cooker is beige and its for a static caravan. Thanks

conway cardinal door?

how does the door system work on 1988 conway cardinal can you by parts

1

Habitation checks were can i go to get it done?

Hi I would like to have a habitation check done on my motorhome a 1996 ford tranny autosleeper. Can anyone re... [Read more]

Help required to replace tank drain taps and refit tanks?

Hi can anyone tell me who can drop my tanks and replace tank drain taps plus any other tank fittings required ... [Read more]

1

how to remove screws from inspection plate that are rusted solid?

hi I am trying to remove the plate in front of the gas burner on my carver water heater but the left hand scre... [Read more]

1

how can I re-connect the wires in the control box of my carver rapide ge?

the wires in the control box on my carver rapide ge need to be re-connected can any one help with advice as to... [Read more]

1

Heating not working?

Hot waterside is working Heating system will not cut in

1

I am seeking help regarding a wiring diagram for a carver Rapide GE ?

due to frost damage I had to replace the bar that secures my Carver Rapide GE water heater. The plastic box wh... [Read more]

2

carver cascade water heater fuse?

I have a mk 2 carver cascade water heater and I am looking for the 5 amp fuse for it. It states in the manual... [Read more]

no lights on control panel were is the 5amp fuse?

carver cascade water heater mk2 I have no lights on my control panel can any one help I need to know were the ... [Read more]