Mend > Tractors

1

JCB 3C wheel nuts (left or right hand thread)?

Hi, Can anyone tell me if the wheel nuts on the left side of a JCB 3C mk11 are normal righthand thread or l... [Read more]

1

jcb 3cx?

hi i have an old 3 cx which goes ok in reverse but wont go at all forward. Is there any other checks I should... [Read more]

1

newholland tm165?

the tm screams and by pushing the 4wd,or diff lock,or change gear it stops any ideas

how to fix hydrostat transmission on 1999 4300 john deere tractor?

i have a 1999 4300 john deere tractor that the hydrostatic transmission jumps out of low range and stays in hi... [Read more]

2

runs rough then dies, wont start back up for hours?

runs rough then gets real rich then dies, and wont start back for hours?

1

what is the difference between begun bearing and big end bearing?

what is the difference between begun bearing and big end bearing,please clarify thanks .

1

water in my oil in jcb mark 3 leyland 1978?

water is in the oil of my engine, i replace head gasket had head tested & skimmed & it still has water getting... [Read more]

1

pell job eb12?

Where would I find the lift pump on an (old) Pell Job EB12. Been standing for a number of years and will now o... [Read more]

need more thrash?

my english electric type three tractor needs to belch more black smoke for the diesel cranks that follow it ar... [Read more]

1

how do you add hydraulic fluid to a David Brown 990 tractor?

I have a David brown 990 tractor and I can not figure out where the hydraulic fluid goes I need help please!!

where can i get spikes for a selectatilth?

where can i get spikes for selectatilth and how much will it cost

Location on relief valve hydrualic pressure pump 2040 JD?

tractor wont start battery good new rebuilt starter suspect hydrualic pressure loading up while cranking start... [Read more]

2

engine problems? jcb 3cx?

Engine is slow to turn over even with fully charged battery, when and if it does start it wont run for longfro... [Read more]

3

Westwood T1200 will not start?

Hi, My Westwood T1200 has decided to stop working! Whenever I try to start, it tries to turn over but just w... [Read more]

steering part for gary market kubota?

I need the steering shaft /bearing and bushing for my b7100 kubota serial # b7001-55689 Curtis 408-981-8886 C... [Read more]

Kubota 4050DT?

The loader will not raise and doesn't seam to be building any hydralic pressure. How do I check the level? Tha... [Read more]

1

new holland 8360?

when i'm trying to calibrate the clutch packs u19 keeps coming up

1

transmission very warm on matbro TR250-110?

the transmission on a matbro TR250-110 powershift gets very warm and then starts to jump

how hard?

I need to change the rear main seal in a allis chalmers 160 how hard is it to separate the motor and trans and... [Read more]

1

E46 error in N.H. 7740 tractor?

How do i fix?