Mend > Chainsaws

1

My Brand new McCulloch chain saw will not start!?

It's a McCulloch 18" chainsaw, 46cc. I am having trouble getting the engine to start. I have followed the ins... [Read more]

2

My Mc Culloch will not restart after running for a while?

After taking care to mix new fuel in the correct ratio, I use the saw for a while but it will not re-start.

1

homelite super xl automatic?

saw will not run with new air filter or with just air filter cover on? the saw runs fine without either items ... [Read more]

1

how can I fix homelite chainsaw?

the rope does not pull out smooth. It catches and thesaw will not start. I have changed the starter pulley bec... [Read more]

1

HOW TO PUT CHAIN BACK ON CHAINSAW?

HOW CAN I PUT CHAIN BACK ON MY CHAINSAW

2

identification of the carburetor used with a Homelite 330 chainsaw?

Does anyone out there have any knowledge on the carburetor that was used with the Homelite 330 ? Thanks.

1

How do I change the clutch drum on my Echo CS-440?

I have an Echo CS-440 in the 800000000 serial number range and can not take the clutch drum off?

1

pollaun 2000?

when i start it . i choke it first till it about to start then open up the choke and it will run and rev up fa... [Read more]

6

what is my problem with my poulan 2000 when idle?

when i start it . i choke it first till it about to start then open up the choke and it will run and rev up fa... [Read more]

1

How do I replace the drive sprocket on my Homelite 240 chain saw?

I replaced the drive sproket on my Homelite 240 chain saw, but when I try to tighten up the retaining nut, the... [Read more]

2

stihl saw will not start now?

I have a stihl saw TS 350, was working but not running great,...... will not start now and there is no spark, ... [Read more]

1

how do I remove clutch assembly?

how to remove clutch assemby on a Poulan chain saw model 2150

1

how to stop the self bar oiler from leaking?

I have a 14'' saw and I can't figure out how to make it stop leaking bar oil!!!

1

Carb ajustment McCulloch chain saw 600032-32 mac 3214?

On The Zama carb there is a h & l carb ajustments I want it factory set

1

How can I put the chain back on my craftsman chain saw?

How I can put the chain back on my craftsman chainsaw modle #41AZ63NQ799?

1

what is gas-oil mixture for homelite 360 chainsaw?

what is the gas oil mixture for a homalite 360 professional chainsaw

2

where do the gas lines go on an 18" cfaftsman chainsaw? (3 lines)?

I'm replacing the gas lines & don't know where the lines went. There are 3 lines 2 go in the tank, one of whi... [Read more]

2

my poulan chainsaw will not start after using it?

after using my poulan chainsaw and it is hot it will not restart How and what should I lfor to fix it

3

need to adjust carburator on mcculloch chainsaw?

how to adjust carburator on mcculloch chainsaw

2

How can I fix my homelite 360 ut104684?

This saw would not idle properly, so I removed the carb, underneath was this melted blob of rubber. So I order... [Read more]