How to mend Control Reset Board

1

Control panel not working on Zanussi washer dryer zwd 1471s?

I had pressed the skip/reset button there was a flash of light and a bang from the top right had corner of the... [Read more]

no mains power to super 50 90 oil burner?

after bleeding my oil burner, i pressed the reset button and noticed that there was no power, i checked the fu... [Read more]

1

Kenmore Ultra Wash Dishwasher model 665.13779 Flashing light & Unresponsive?

Does anyone know the reset code for model 665.13779? The red lights on the "normal wash" and "cancel" buttons... [Read more]

Controller reset sequence for Bosch WFR2860 washing machine?

I have a Bosch WFR2860 washing machine with a problem I believe to be the on the main processor/controller boa... [Read more]

hotpoint sdw60 not working/ no prog select?

my sdw60 dishwasher stopped working, 1st off 2 of the prog led's started flashing(think it was the pre-wash an... [Read more]

Kenmore Elite Ultra Wash Quiet4 Control Board Problem ?

Here are the steps I follow. > Control panel is off > Touch Smart Wash, the board powers up > Smart Wash an... [Read more]

4

Worcester 19/24CBI Problems (Over Heating, Fail to ingite)?

Hoping that someone can shed a little light on my problem or that this may help someone in a similar position.... [Read more]

micron 55FF no LCD lights?

Glow worm micron 55FF, no reset or burner lights on Just stop working, when it was on. RWB2 timer control has... [Read more]

4

LG WM2277HW will not respond to power button?

I ran about three loads of laundry through this washer yesterday. Woke this morning to run one more load, and... [Read more]

bosch 1200 that wont spin?

i have a bosch 1200 classixx express that wont spin .i have put new brushes on ,checked and cleaned everything... [Read more]

2

Zanussi TCE7227 Condensing Tumble Dryer - Intermittent fault?

The dryer starts but suddenly stops again. I have replaced the motor capacitor on a previous occasion and this... [Read more]

How to Reset the Control Board and Run the Diagnostics in a GE QuietPower d?

How to Reset the Control Board and Run the Diagnostics in a GE QuietPower dishwasher Model #GLD4200L00BB

1

Sportcraft TX400 stopped abruptly when I touched the control panel. ?

It seems static electricity fried the circuit board because a spark did fly from my finger to the switch when ... [Read more]

2

Norcold N611 five flashes?

my norcold N611 refrigerator is giving five flashes on the control light, i believe that you can reset the cir... [Read more]

1

alarm code reset number?

i have an veritas r8 plus alarm system i cut through the wires but have repaired that it blew a fuse on the c... [Read more]

2

My central heating does not work, it firesup then cuts out after 20 seconds?

I have a condensing fanned boiler the CSI 85T. The problem I have is with the central heating side in that whe... [Read more]

1

Veritas R8 lost power to control board?

My power was shorted out from a bulb blowing and now the alarm control panel will not accept any codes. The al... [Read more]

1

ideal icos m3080?

My ideal icos is only two years old and for some reason it just wont run. ita a conventional boiler on a press... [Read more]

1

Kenwood A901 Speed control?

I took charge of a Kenwood Chef A901 but the previous owner had removed the small components from the speed co... [Read more]

2

potterton envoy 40?

please could someone help me...i have a potterton envoy 40 condensing boiler....the boiler only runs for about... [Read more]