How to mend Cylinder 2 Valve

How to top-up a Glow-worm Micron domestic boiler?

Asking this question for a distant elderly relative, before she gets ripped off by yet another crooked plumber... [Read more]

5

No hot water from Danesmoor bolier?

I have a boiler danesmoor 15/90 and now can not get hot water from taps. ..just cold running water. Have check... [Read more]

No hot water from Worester dansmoor 15/90?

I have a boiler dansmoor 15/90 and now can not get hot water from taps. ..just cold running water. Have checke... [Read more]

2001 Ford Puma 1.6 16v Zetec-S leaking oil inside spark plug hole Cyl one?

2001/2 Ford Puma 1.6 16v Zetec-S leaking oil inside the cylinder No 1, spark plug thread/electrode is covered ... [Read more]

1

How can I mend my Danfoss thermostatic cylinder control valve?

Danfoss have just told me that my Thermostatic cylinder control 2 part valve and thermostat 22mm, gravity fed,... [Read more]

how to set valve timing on gilera 125 vx runner 4 stroke ?

i am about to replace the cylinder head on my mates gilera 125 SOHC scooter.. Can you tell me where the timing... [Read more]

2

THE WORKINGS OF A PUMPED C/H SYSTEM AND AGRAVITY FED H/W?

I have an Ideal WLX RS50 Boiler.I recently fitted a new 2 port zone valve and pump in the c/h .All operating o... [Read more]

Danfoss motorised valve - 2 port?

Hi, My hot water is extremely hot. The cylinder stat works and is wired ok. I have replaced the head only of... [Read more]

1

not going to mid position on valve?

when I replaced the actuator on the mid position valve and controler I found that I could get heating and i co... [Read more]

1

Spring pressure valve on an open vented system?

I have an open vented system with Baxi bermuda inset 2 back boiler (10 years old), indirect water cylinder (gr... [Read more]

1

what else could the problem be?

i have a zafira 02 plate which missfires in cylinder 2 yet i have had egr valve fitted breather hoses cleaned ... [Read more]

2

how can i stop my indirect combination cylinder overflowing BS3198:1981?

Hi there, Help needed to fix overflow problem I have a McDonald Engineers Hot Water System. Spec: Indirect ... [Read more]

3

Can I run my boiler without the CH pump for Hot Water only operation?

My heating system comprises new(ish) boiler (Potterton Suprima 100), hot water cylinder (with cylinder jacket)... [Read more]

1

why is my 2.0sohc pinto only running 3cylinders??

cylinder2 is will not ignite. (other 3 cylinders are running ok).-compression on ALL cylinders is 160psi. fuel... [Read more]

3

IDEAL CLASSIC BOILER ONLY STAYS ON FOR 2 MINUTES?

My Ideal Classic FF280 will only stay on for 2 minutes then cuts out. I have recently been having problems ... [Read more]

1

baxi 100 he system fault?

boiler reaches temperature but but pump stops after aprox 2 minutes will not come back on as no water circulat... [Read more]

1

Renault Clio 1.2 Dynamic 2003. Valve Clearances?

1. What are the Exhaust and Inlet valve clearances? 2. Are these clearances adjusted hot or cold? 3. In ... [Read more]

1

how do i turn my hot water off so i ca replace the taps in my kitchen?

I NEED 2 TURN THE HOT WATER OFF SO I CAN REPLACE THE TAPS IN MY KITCHEN? I HAVE A HEADER TANK IN THE LOFT AND ... [Read more]

1

how do i fix the slave cylinder on a v reg vectra?

i have a v reg vauxhall vectra and the slave cylinder needs replacing. How do i do it! It is a 2 ltr 16 valve!

2

How can I time my VW Transporter 2.5 TDI?

I am looking for valve and pump timing information for a 1999 VW 2.5 diesel, 5 cylinder. Can you help?