Mend > Vacuum Cleaners

How can I fix the roller at the front so that the hoover picks up?

The roller at the front of my vax upright hoover is too high and I cannot lower it so that the hoover picks up... [Read more]

2

how can i fix dyson dc14 animal?

it's about 4 yrs old doesn't pick up well when used verticle, with hose absolutely fine

dirt devil rug shampooer?

what is the problem if my rug shampooer does not suction up the dirty water

My Bissell Power Steamers will not suck!?

I have a Bissell Power Steamer model 1697-w. The handheld pre-treatment's vacuum is fine but the main extracto... [Read more]

main part of Bissell ProHeat 2X will not spray?

I keep this thing emaculate. Clean it throughly after every application. While my hose attachment will spray,... [Read more]

1

how can i fix dyson dc05 complete loss of suction?

my dtson dc05 has completely lost all suction I have cleaned everything,hoover is only 5yrs old

Need a wiring diagram for Kenmore canister vacuum, model #116 23513300?

Had to install a new harness which attaches the hose to the switch. Thought I put all the wires in the right ... [Read more]

1

Vaillant VCW GB 242 EH Central Heating Overheat?

Hi, I'm having trouble with my boiler (actually my Gran's - shes just been quoted £1650 to have it replace... [Read more]

2

How can I fix my Dyson 04?

There is a loose connection where the lead goes into the switch housing. How can I get into the switch housing... [Read more]

how do I open kenmore whispertone 100 to check belt?

The beater bar stopped rotating and I need to check the belt. How do I open kenmore whispertone 100?

1

dyson dc1 not picking up??

my dycon dc1 has good suction on the hose and in full upright position, but seems to lose most of it when tilt... [Read more]

DYSON DC03 Hose jamming in lance, lance wont go into hose?

I have had this for over 5 years and had one service call within the 5 years.All of a sudden it's almost impos... [Read more]

my proaction vc9340s?

how can I stop the push pull handle coming away, leaving the wires exposed?

VAX VS03?

HOW TO DISMANTLE A VZX VS03 TO REPAIR CORD REWIND?

1

DYSON d01?

How do I remove the brushes and change the drive belt?

Hoover moldle F7424-900 need to take of top casing?

The brushes quit working on my hoover carpet cleanre,and after investigating I`ve see the spring to the brush ... [Read more]

Kirby cleaner G7E?

I am unable to remove the stainless steel(?) cover on my Model G7E. I have taken out all the star screws that ... [Read more]

2

Dyson d14 motor what colour leads do i connect?

I have a new motor for a dyson d14 but i dont no what colour leads fit to the dyson d14, The two colours on th... [Read more]

How do I get the hose off the Dyson DC01?

My Dyson DC01 vacuum has lost its suction on the hose how can I remove the hose to see if I have a blockage

Hoover U5720 motor shaft and belt assembly diagram?

i'm trying to find diagram on this unit to see how the belt drive assembly operates