Mend > Vacuum Cleaners

2

Electrolux 2100 Wiring Diagram?

I need a Wiring Diagram for Electrolux 2100 Vacuum!!!

1

i think water got inside my vaccum ..its running but not vaccuming?

i think water got inside my vaccum ..its running but not vaccuming

3

How do I remove the switch housing from my Dyson DC-04?

The flex has broken at the point where the wire enters the switch and I need to replace the end of the wire. ... [Read more]

2

my dyson dc4 has lost suction in the hose?

how do i repair this problem

1

how do i wire a new motor to the existing switch for a electrolux liv1060 v?

wiring of a new motor

2

HOW TO REMOVE THE SWITCH FROM A DYSON DCO4?

THE MAINS CABLE ON MY DYSON HAS SPLIT ALONG WITH THE CABLE PROTECTER GROMET AND I NEED TO REMOVE THE SWITCH IN... [Read more]

3

MY ELECTROLUX LUX SHOWS A FULL BAG YET THE BAG IS NEW WHAT COULD BE WRONG?

MY ELECTROLUX LUX SHOWS A FULL BAG YET THE BAG IS NEW WHAT COULD BE WRONG? I'VE CHANGED THE BAG THE HOSE LOOKS... [Read more]

1

how do I replace the belt on a kenmore canister vacuum?

Kenmore model 2651190

1

how can I fix my dyson dc14?

How do I change the belt on a Dyson DC14

2

How to extract the on/off switch from my Dyson 04 machine?

The cable on by DC04 Dyson has severed adjacent to the Support grommet on the upright. Switch appears to be o... [Read more]

1

How can I chg the belt on my old Eureka vacuum..1966 model?

Hello folks, I have the triangular pan removed from over the melted belt. 7802044 model old Eureka that was m... [Read more]

1

How do I replace the belt on my Hoover Steam Vac Deluxe?

My scrubbing brushes (5) don't rotate when there is any resistance applied to them, but rotate freely when the... [Read more]

1

How would I change the belt on a Hoover vacumm-Model U4617-930?

I need to change my Hoover vacumm belt and listed below is the make, model and serial number. I don't have an... [Read more]

2

my upright vacumm no suction?

I cleaned out the filter because I thought that is why it stopped picking up anything, but it was not that. Ho... [Read more]

1

How can I open the face plate to change belt in Kenmore Whipertone?

I followed the directions and slid a screwdriver in the sides where arrow is pointing to but face place will n... [Read more]

1

kenmore canister powerhead - 12 amps?

How do I take the cover off the powerhead to check the belt and light. I don't see any screws to loosen it

2

Getting at the the motor chamber in Kenmore model 166.26500991C vacuum?

Hi there. I have a Kenmore model 166.26500991C vacuum cleaner. (class CP-JR) I cannot figure out how to get... [Read more]

1

how to change the bag in a dirt devil vacuum cleaner?

I lost my directions and need to change the bag in my Dirt Devil Breeze vacuum cleaner

1

My DC03 works at the attachment handle but no suction on floor plate?

The handle attachments are great, but the floorplate has very little suction. I've checked for blockages and ... [Read more]

3

how do I change my kenmore vacuum belt on modell 116?

how do I change my kenmore vacuum belt on modell 116